manufacture Archives - Boast Site Services Ltd

Compact Tank Suction Upgrade

Boast Site Services Ltd have completed the design, manufacture and installation of an upgrade to the typical square sump tank pump arrangement using the industry preferred solution that’s commonly fitted in feed regulating sumps.

The original steel parts are welded in situ and do not facilitate ease of service and replacement. These had to be cut out to enable replacement.

New arrangement incorporates the cast iron suction bend, flexible hose and lined suction pipe to two piece steel pipes with quick release sleeve fitted with Boast SS clamp assemblies.

Silt Pump Pipework and Motor Support Upgrade

Boast Site Services Ltd have completed an upgrade to both the suction/ inlet and discharge/ outlet pipework together with a new motor support to a pit mounted silt pump.

Previously the inlet pipework had the tendency to block due to poor suction arrangement and there was no means to isolate the pump for maintenance. A duty increase also necessitated a larger motor which could not be mounted on the existing support that currently flexed!

For all your Sumps Requirements

Another busy weekend at Boast Site Services Ltd.

Out with the old and in with the new!

Utilising the existing support legs and sump internals/ access platform for cost savings.

For any sand plant upgrades or technical support, please get in touch!

Bespoke Compact Sand Plant

Boast Site Services Ltd undertook to design, detail, manufacture, supply, offload and erect a new bespoke compact sand plant for our customer to replace an old bucket wheel dewaterer.

The plant was designed to handle up to 60tph -4.0mm material and produce a single sand fraction with <3% -63 micron.

We included the preferred Linatex lined centrifugal pump, dewatering separator and dewatering screen in our design and all components exposed to the abrasive slurry were Linatex lined for unbeatable wear resistance.